Tools:
Drill and drill bits for glass
Clamps
Screwdriver
Diamond crowns
Cable cutters
Clamps
Screwdriver
Diamond crowns
Cable cutters
Materials:
Bottle of wine
Socket Cap
Switch
Power cord
Wooden block
Adhesive
We are going to tell how it's done step by step:
Step 1
The first thing we have to do is immobilize wine bottle in order to work safely and boring side to remove the cable to attached Cap socket with switch. With a wood and two clamps that we will adapt to the neck of the bottle and the body, in this way we avoid vibrations which can break the glass.
The first thing we have to do is immobilize wine bottle in order to work safely and boring side to remove the cable to attached Cap socket with switch. With a wood and two clamps that we will adapt to the neck of the bottle and the body, in this way we avoid vibrations which can break the glass.
Step 2
Let's use a bit of glass to pierce the side of the bottle. At the beginning we will use a bit thinner than the cable and then go to widen it with another bit of the size of the cable which we must pass and thus avoid breaking it. It is important to use safety goggles if you skip any chip glass. Place the drill in the position of striker.
Let's use a bit of glass to pierce the side of the bottle. At the beginning we will use a bit thinner than the cable and then go to widen it with another bit of the size of the cable which we must pass and thus avoid breaking it. It is important to use safety goggles if you skip any chip glass. Place the drill in the position of striker.
Step 3
Once the side hole we have to proceed to the ass of the bottle empty. We will use diamond of the size of the widest part of the bulb.
Once the side hole we have to proceed to the ass of the bottle empty. We will use diamond of the size of the widest part of the bulb.
Step 4
With same diameter measurement we will make a piece of wood which serve as a basis for the socket Cap. This same piece we will have to make another hole inside the diameter of the CAP so that it can fit. In addition, on one side we will make a recess that pass the cable.
With same diameter measurement we will make a piece of wood which serve as a basis for the socket Cap. This same piece we will have to make another hole inside the diameter of the CAP so that it can fit. In addition, on one side we will make a recess that pass the cable.
Step 5
Proceed with the Assembly of the electrical system. Once cut the cable to measure, we open with a screwdriver the switch and make the connections. Once we have put switch we pass the cable through the hole in the bottle to place the cap on the inside.
Proceed with the Assembly of the electrical system. Once cut the cable to measure, we open with a screwdriver the switch and make the connections. Once we have put switch we pass the cable through the hole in the bottle to place the cap on the inside.
Step 6
We dismantle the CAP. Now put the piece of wood, the trim of the CAP first and finally make the connection. We stick the CAP to the wood with adhesive. Put the bulb, it introduce everything in the inside of the bottle and we can now enjoy our lamp made with a bottle of wine.
RESULT:
Comments
Post a Comment